How to Use OBDSTAR X300 DP Plus Clone ECU for GM Opel Bosch BCM
This article show a guide on how to use OBDSTAR X300 DP Plus to clone GM Opel Bosch BCM.You can copy the original ECU data,and then write the data into another same ECU hardware via X300 DP Plus,so that it can achieve the same function as the original ECU.Let’s jump right in!
Procedure:
Select “ECU Clone”==>GM
GM V30.01,and tap “OK”
Select “Auto” and tap “OK”
It prompt with the information “This function is available by connecting the server,please ensure the Internet connection is normal”
Tap “OK” to continue
Select “Read EEPROM”,and click “OK”
Enter a filename to save
File saved success
Select “Read FLASH”
Enter a filename to save
Click “Write EEPROM”
Select the data file you saved before
Logging system…
Restoring EEPROM…
Successful data recovery
Select “Write FLASH”
There are certain risks in operating this function.Does it continue?
Remember:During operation,make sure that the vehicle is fully powered and do not disconnect the device.Tap “OK” to continue
Select the FLASH file you saved before,then tap “OK” to continue
Logging system…
Restoring FLASH…
Successful data recovery
Done!